View Single Post
Old April 13th, 2008, 09:45 PM   #5
Tab
Senior Member
 
Tab's Avatar
 
Join Date: 11-05-05
Location: Freeland, mi
Posts: 4,691
iTrader: (29)
I will. Cost depends on current steel prices. They have gone up quite a bit in the last few weeks, for plate anyways. I would say $50 each give or take a few bucks. I can do pretty much any design too unless you like this one.
Tab is offline   Reply With Quote
 
Page generated in 0.03059 seconds with 11 queries