Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - JP fabrication?
Thread: JP fabrication?
View Single Post
Old April 13th, 2008, 01:12 PM   #291
Senior Member
Tab's Avatar
Join Date: 11-05-05
Location: Freeland, mi
Posts: 5,550
iTrader: (31)
Mentioned: 51 Post(s)

Originally Posted by jeeperbrian View Post
that wasnt finished product, notice its not bolted on yet
So when it got finished was the leading edge cut at least sorta straight? That usually isnt a touch up detail, it should be cut straight to begin with and the finish details would be smoothing edges and countersinking holes.
Tab is offline  
Page generated in 0.12846 seconds with 22 queries