Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - traction bars
Thread: traction bars
View Single Post
Old April 4th, 2006, 11:49 PM   #11
PavementPounder
I am the law.
 
PavementPounder's Avatar
 
Join Date: 11-05-05
Location: Birmingham, Michigan 48009
Posts: 29,824
iTrader: (224)
Mentioned: 2 Post(s)
Default

Quote:
Originally Posted by sonic
The Cepek long arm kit requires that you notch out the body mount below the front doors to allow for the upper arm to travel heres kind of a bad pic to show how they mount. You have to cut the old upper controle arm mount off ass well.
I don't think you had to do that with mine (Skyjacker) - would have to take a closer look. I think the only cutting that had to be done was around the arm mounting point on the axle to make room for the big joint and so you could tighten the nut.


You could drive over here and look at it sometime this weekend if you want.
PavementPounder is offline   Reply With Quote
 
Page generated in 0.05255 seconds with 20 queries