This will finally get put together ! I'm looking at running a lot of the parts off my jeep plus some new cool stuff lolso as of now it will be on a 14 bolt rear four link a 60 front four linked full hydro . 16 inch rear 2,5 air shocks and 14 fronts. 2.5 four inch travel air bumps all four corners. aluminum lower links with 1.25 joints.44 cut boggers on 16.5 h1s.
built 92 fuel injected 302 running on e-85 with a c-6 and 205 combo. im ether going to run 1350 or 14xx drive shaft joints just not sure yet.it will have an artcar shifter and a jb fab twin stick kit. all the seats will be corbea with five point harnesses. im sure im missing something so I will update as parts come in !
Well I stopped by to use the barn with sjherderson18 to help him on his ranger for a min .. Then I went in to see Ugly Betty I mean pretty woman and I seen my old power plant eye balling me so I gave her some lovin
it sure seems like these 2 tubes are going to interfere with shocks/wheel travel. maybe the chassis is super skinny and it wont. but I would think they would get flipped the other way to make an inner fender area.
He left the bottom of the chassis narrow enough that shocks should clear. That is where it was the tightest on clearance. If he has a little less backspace than what I had and goes for a touch higher ride height than me I think it will be fine. In its previous life I had clearance for 16" coilovers.
I think it will work as is I put the tape on my jeep and its skinner then my jeep where the shocks mount so I think it will be ok .........I think :sonicjay:
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Great Lakes 4x4. The largest offroad forum in the Midwest
4.2M posts
30.9K members
Since 2005
A forum community dedicated to Great Lakes 4X4 owners and enthusiasts. Come join the discussion about performance, trails, tires, modifications, classifieds, troubleshooting, maintenance, and more!