Great Lakes 4x4. The largest offroad forum in the Midwest banner

Mr. Beefy's "not quite yet U4 buggy" build

358K views 3K replies 117 participants last post by  Mr. Beefy 
#1 · (Edited)
Alright fine, I'll make a new build thread :finger: :sonicjay:

Bought a MandM offroad chassis from PJ, super good dude to deal with and super nice. HIGHLY recommend. http://mandmfab.com/id68.html
This is chassis #20

Order placed on Monday 11-5 at about noon..

Got this on 11-6.




11-9






11-12


11-13

 
See less See more
10
#979 ·
Ok, I am leaving work at 5am then heading to Meijer for some shopping. Should be heading north from 54th and US-131 by 6.
 
#1,004 ·
It wasn't me
me either
It wasn't Rich's son either.

Who else drove the buggy in the park?
I didn't break it...
Don't forget Frdboy or General....they didn't break it :sonicjay:.

Like I told beef when it happened, he was doing nothing I wouldn't of done at the time. And besides its the spotters fault when something breaks right? Well I was spotting him when it happened :beerbang:
 
#997 · (Edited)


Broke both inner shaft ears but didn't break the joint. Fwiw the shaft that broke also was the one that had a twist on the splines at the carrier. And was the original inner from the first 60 I ran. So that shaft is 5 yes old, has seen one or two broken stubs, and was also in the 60 that I bent and twisted the tubes on. So that shaft was well over due. And I am sure when beefy shows the video of what I was doing 10 minutes before the break, you'll see that it really should of broke on me lol. Hoping to salvage the stub for a spare. Time to get new shafts. What's the scoop on shafts now a days. Rcvs are to expensive, I've heard superiors aren't what they used to be.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top