Great Lakes 4x4. The largest offroad forum in the Midwest banner

BBC parts, HT starter, cam, carb, etc

4K views 39 replies 9 participants last post by  moparhorse 
#1 · (Edited)
-Solid lifter cam from Comp with lifters #11-324-4 814 $100 Only broke in and then has a few dyno pulls on it
-Mallory distributor $45
-Steel valve covers and timing cover $35
-Balancer for steel crank $25
-High torque starter from powermaster $75
-Holley 850 double pumper that was done by barry grant. $650



Brandon 989-513-4827
 
#12 ·
Interested

Interested in your big-block. Couple questions;
was everything Magnafluxed prior to build (General condition)?
Forged/HyperU Pistons?
Expected compression?
H-beam/I-beam Rods?
Head Casting (Open Chamber 049, Closed Chamber 290/702 ) Final CC after porting?
block Casting number?

Tins included?
In WI, Where -R-U?

Thanks,
78
 
This post has been deleted
#17 ·
Heres a good one if you looked up the numbers on the camshaft. It says its a hydraulic camshaft, and we ran solid lifters in it. Im not sure what happend. When we bought the cam it came with solid lifters, which I still have that I put in a box thats numbered for each cylinder so I could put them in the same place when put back together. It has a couple other numbers on back lobe of cam that are stamped in it. Not sure what they are?
 
You have insufficient privileges to reply here.
Top