Great Lakes 4x4. The largest offroad forum in the Midwest banner

Parting out a 92 Wrangler yj

6K views 56 replies 25 participants last post by  knobbie 
#1 · (Edited)
Alright I am parting out a 92 YJ. It currently has the 4.0 out of a 97 XJ that I bought from a guy on here but I got another vehicle shortly after installing it. It also has the AX 15 trans and an NP231 transfer case. Dana 35 rear and Dana 30 front axle they are both 4.10 ratio and the front axle shaft has been changed over to a tj shaft.

The front axle pinion bearing has a little bit of play in it but the gears looked solid when I last had them open.

The AX 15 definitaly needs a rebuild the 3rd gear synchro is worn and the 4th/5th gear bearings are noisy.

The engine is in great shape and runs very strong.

These are my asking prices for everything only reasonable offers will be enertained.

Engine 4.0L $550.00 SOLD
Trans AX15 $250.00
Transfer case $225.00
Dana 30 front $75.00 SOLD
Dana 35 rear $85.00
Hood $50.00
Family roll bar $100.00 SOLD!
Grill $50.00
Tub/title/frame $250.00

All other parts just ask me for prices. I would consider trades for a 33'x12 MT's. Also this jeep has 3' lift spring and I am selling a set of stock xj coils and leafs.

 
See less See more
1
#27 ·
I am willing to sell the tub and frame but the tub is not in very good shape as rust has gotten the better of several pieces of it. The frame on the other hand is solid. It only had a rust problem behind the rear shackles near the bumper and a friend and I cut that out and welded in some new material to eliminate the problem. It was not a hack job it was cut and bent to fit quite nicely. Also I have not had a second to check out that cable for you addicted but I will take a look at it tomorrow. Thanks
 
You have insufficient privileges to reply here.
Top