Great Lakes 4x4. The largest offroad forum in the Midwest banner

Mr. Beefy's "not quite yet U4 buggy" build

358K views 3K replies 117 participants last post by  Mr. Beefy 
#1 · (Edited)
Alright fine, I'll make a new build thread :finger: :sonicjay:

Bought a MandM offroad chassis from PJ, super good dude to deal with and super nice. HIGHLY recommend. http://mandmfab.com/id68.html
This is chassis #20

Order placed on Monday 11-5 at about noon..

Got this on 11-6.




11-9






11-12


11-13

 
See less See more
10
#195 ·
I need some new drill bits or bring my drill doctor home. Wanted to get the engine and trans crossmembers done, but my 1/2" bit was to dull to cut so I couldn't get the trans mount built. But I did get the engine mounts done. With the clocking ring I was able to lower the motor a little more then where I had it before.





 
#592 ·
that is a LOOOOOOOOONG lever arm for the engine mount bolts to support, especially on a jump or bouncing. I would think about moving the poly bushings to directly under the engine, and running a tube from the chassis out to the bushing. Basically the exact opposite of what you have now.

This is how I did mine
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top