It all started about a year ago today. I snapped my frame
Here is a pic of the old YJ stripped down before I torched it up
Ok, looks like I found a donor frame.. With some kick ass hardcore axles :tonka:
Heres my tub fresh off the junked frame.
What good is a jeep with a 4 banger? Heres the TPI setup after I was done with it. Its so pretty.
Ok, put in the engine, trans (700R4) and t-case (dana 300 twin stick with flip kit)
Aluminum four link installed.
14 Bolt rear 5.13 gears, detroit locker, disc brakes
Trans support mounted
Tub installed, then Blue torch comp cut crusher corners installed
Boggers, Rims and windshield frame attached
March Performance underdrive serp kit installed
Wiring harness complete figured out and spliced out, ready to plug into the dash. You can see the computer on the passenger side.
As soon as I get the radiator installed I am going to run the engine for a while and make sure everything is wired rightbefore I tape and hose the harness
Just got these blue torch sliders. Need to mount them up.
It looks like a jeep again!
Tube fenders utilizing the stock inner fenders.
another shot
Front bumper with winch plate and fairlead tabs.
The ENTIRE front clip is bolt on.
All the tubing was done in the same size. The sliders are Blue Torch Fabworks. Everything else was done from JCR.
Another view
Rear frame tie-in for the cage.
Middle cage tie-in. Utilizing the slider bracket.
Rear bumper setup, with rear shock mount.
Front inner fender tabs, and the attachment to the tub.
Mismatched fenders is a good look!
paint, somewhat complete here.
dana 60 with some tasty treats all installed. Probably not the best $6k I've ever spent, but whatever.
Here is a pic of the old YJ stripped down before I torched it up
Ok, looks like I found a donor frame.. With some kick ass hardcore axles :tonka:
Heres my tub fresh off the junked frame.
What good is a jeep with a 4 banger? Heres the TPI setup after I was done with it. Its so pretty.
Ok, put in the engine, trans (700R4) and t-case (dana 300 twin stick with flip kit)
Aluminum four link installed.
14 Bolt rear 5.13 gears, detroit locker, disc brakes
Trans support mounted
Tub installed, then Blue torch comp cut crusher corners installed
Boggers, Rims and windshield frame attached
March Performance underdrive serp kit installed
Wiring harness complete figured out and spliced out, ready to plug into the dash. You can see the computer on the passenger side.
As soon as I get the radiator installed I am going to run the engine for a while and make sure everything is wired rightbefore I tape and hose the harness
Just got these blue torch sliders. Need to mount them up.
It looks like a jeep again!
Tube fenders utilizing the stock inner fenders.
another shot
Front bumper with winch plate and fairlead tabs.
The ENTIRE front clip is bolt on.
All the tubing was done in the same size. The sliders are Blue Torch Fabworks. Everything else was done from JCR.
Another view
Rear frame tie-in for the cage.
Middle cage tie-in. Utilizing the slider bracket.
Rear bumper setup, with rear shock mount.
Front inner fender tabs, and the attachment to the tub.
Mismatched fenders is a good look!
paint, somewhat complete here.
dana 60 with some tasty treats all installed. Probably not the best $6k I've ever spent, but whatever.