Great Lakes 4x4. The largest offroad forum in the Midwest banner
281K views 3K replies 91 participants last post by  jbsjunk 
#1 · (Edited)
This will finally get put together ! I'm looking at running a lot of the parts off my jeep plus some new cool stuff lolso as of now it will be on a 14 bolt rear four link a 60 front four linked full hydro . 16 inch rear 2,5 air shocks and 14 fronts. 2.5 four inch travel air bumps all four corners. aluminum lower links with 1.25 joints.44 cut boggers on 16.5 h1s.
built 92 fuel injected 302 running on e-85 with a c-6 and 205 combo. im ether going to run 1350 or 14xx drive shaft joints just not sure yet.it will have an artcar shifter and a jb fab twin stick kit. all the seats will be corbea with five point harnesses. im sure im missing something so I will update as parts come in !
 
See less See more
2
#424 ·
I ordered brackets from artec over a month ago and they are still on back order wtf


Sent from my iPhone using Tapatalk
 
#445 ·
I just need a few more little things like drive shaft parts, my motor rebuilt (strangler), my trans rebuilt (tranytom), engine harness and computer and a few tabs and a truss that I already ordered lol
 
#447 ·
12voltguy.com or something like that I stole the idea from the west side haha


Sent from my iPhone using Tapatalk
 
#457 ·
yup that's the only thing that I saved from it :sonicjay: well that and the tires but I just cant bring my self to sell those :naughty:
 
#459 ·
:sonicjay: nice. is that motor from farvas old mustang going into this buggy? can't rememeber what it was lol
yup but im making it better :sonicjay: can you say stroker :woot:
 
#460 ·
no pics yet but I picked up everything for my skid plates yesterday it will be all aluminum with cutting board over it lol should slide like a mofo
 
#462 ·
I have two things holding me up at this time . but good news is all my axle truss stuff and brackets should be here in the next week or so and then its go time!!!!
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top