Great Lakes 4x4. The largest offroad forum in the Midwest banner

help 95 s-10 bazer t-case no shift, electronic

2K views 13 replies 7 participants last post by  GMCsonoma94 
#1 ·
My mom has a 1995 s-10 blazer.

She's having issued with the 4wd.

It has new switches, that have been tested and are good.

all I get is ckicking from the module behind the dash. and the 4hi nd low lights will flash and both stay on......

I'm looking for where to start looking for issues.
 
#11 ·
if you did not figure it out my guess would be the vacume acutator under the battery. My 1996 did the same thing and the acutator was shot. I replaced it and it works like a champ now.
 
#12 ·
KaiserJeep said:
if you did not figure it out my guess would be the vacume acutator under the battery. My 1996 did the same thing and the acutator was shot. I replaced it and it works like a champ now.
thats just the front axle actuator, it has nothing to do with the flashing lights in the dash for the electronic shift 4x4.
 
#13 ·
aight, well when my acutator went out, the 4x4 light flashed on the dash to tell me, "Hey, don't do anything stupid, you don't have 4x4" I checked the motor, fuses, etc and all was good. I replaced the acutator, light came on steady and I had 4x4.
 
#14 ·
KaiserJeep said:
aight, well when my acutator went out, the 4x4 light flashed on the dash to tell me, "Hey, don't do anything stupid, you don't have 4x4" I checked the motor, fuses, etc and all was good. I replaced the acutator, light came on steady and I had 4x4.
the light will flash untill then axle and t case are ingaged, but tonka has 2 lights flashing where you only had 1 im assuming. i had the same exact thing as tonka, where it flashed both high and low because it couldnt get anything to work.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top