Great Lakes 4x4. The largest offroad forum in the Midwest banner

Yj wiring with v8

1K views 8 replies 5 participants last post by  masterbeatty 
#1 ·
Ok so I bought a manual and I've been staring at this thing, harness is a 95. I'm putting a carbed big block ford in it. For some reason I'm running the struggle bus. I need to supply a trigger wire to my starter relay. I need power for lights, wipers, I think that's it. I feel like I'm over thinking all this. Out of my harness to the fuse box on the pass fender what wire do I need to pull for a starter relay. Now lights and everything body should be run off what I have like it normally would if it had a 4.0 I'd assume. So I shouldn't have to touch that. My distributer should just need a hot lead correct?
 
#7 ·
this is the firewall bulkhead connection. When looking at it in the Jeep from the front, the right side is for all your headlights, horn, wiper squirter etc, the left side is what you want to start probing. I'm about to start a similar swap except mine is a TBI Chevy 350. Hope this helps.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top