Great Lakes 4x4. The largest offroad forum in the Midwest banner

locker issue

2K views 19 replies 12 participants last post by  974x4Taco 
#1 ·
hello just seeing if anyone had a rough idea of what i have going on..just had gears done in my wrangler dana30 front, 44 rear, went from 373s to 456. didnt have to change carriers just the ring and pinion. every seems good until i put the jeep in 4 wheel drive and when it is the lock right locker wont disengage at all.. wether im in the gas or not. so its pushing all over the road binding up like i have a welded front end. the only way it unlocks is if i put it in 2wheel drive put it in reverse tap the gas and then its fine back in 2wheel unlocked. anyone have an idea? thanks for the help
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top