i origanally bought a 79 bronco that was compleatley stripped from all body panels and interior bacically axles frame and body
as you can see here
then i decided to pull the axles out from under the bronco and proceed to strip the stock axles out of my 2001 jeep cherokee seen here
then after the rear axle was pulled the ford 9in was all prepped and ready for instalation
then the rear was all done the pinion angle set
then came the hard part finding out where the ford radius arm mounts go on the unibody frame
we kept running into problems lining the coils straight so it is about as straight it can be right now without wedges under the coil mount
finished steering pictures
the track bar welded up
as you can see here
then i decided to pull the axles out from under the bronco and proceed to strip the stock axles out of my 2001 jeep cherokee seen here
then after the rear axle was pulled the ford 9in was all prepped and ready for instalation
then the rear was all done the pinion angle set
then came the hard part finding out where the ford radius arm mounts go on the unibody frame
we kept running into problems lining the coils straight so it is about as straight it can be right now without wedges under the coil mount
finished steering pictures
the track bar welded up