V10 Idler Pulley Bolt Size - Great Lakes 4x4. The largest offroad forum in the Midwest

PavementPounder · July 23rd, 2006, 07:10 PM

Mine got ejected. Looked at the hole with a mirror and the threads look fine except for the very outer edge were they look a little beaten. Maybe I'll chase them with a tap anyway...

If nobody has a resource to provide to look this up and if his majesty Jesus would be so generous, I would like to borrow his in order to match it at a fastener supplier. It would be replaced with the proper Loctite (after my experience).

Proper compensation would be provided in the form of beverages (not limited to beer).

Haggar · July 25th, 2006, 09:57 AM

I'll take a look about pulling it and measuring it... very busy this week...

Haggar · July 25th, 2006, 11:32 AM

Do you remember what socket size it took to remove it? Truck is a couple hundred feet from my tool pile...

PavementPounder · July 25th, 2006, 01:21 PM

We grabbed 3, maybe 4 wrenches in order to pull both the Ram and the Jeep 4.0 pulleys. IIRC, sizes we had in our hands were about 12-16mm and the head of the Ram bolt was bigger than the 4.0.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Register to remove all ads. Registration is free! Sponsored Links
Great Lakes 4x4. The largest offroad forum in the Midwest Advertisement